MACTek VIATOR Interface Installation 1.03

MACTek VIATOR Interface Installation is the official driver and setup package for MACTek’s VIATOR HART communication interfaces. It prepares a Windows PC to communicate with HART-enabled field instruments through MACTek USB or RS-232 VIATOR modems, allowing you to use your preferred device configuration or asset management software with minimal setup.

The installer adds the required system drivers, creates a stable virtual COM port, and streamlines detection of the connected VIATOR interface. After installation, most HART configuration tools can select the assigned COM port to perform device configuration, diagnostics, calibration, and data collection.

Key features:

• Vendor-provided drivers for MACTek VIATOR HART interfaces
• Automatic device detection and COM port assignment
• Works with HART software that communicates via serial/COM-port modems
• Suitable for commissioning, maintenance, and troubleshooting in plant or lab environments

Basic installation steps:

• Close any HART applications.
• Run the installer with administrative privileges.
• Connect the VIATOR interface when prompted.
• Confirm the assigned COM port in Windows Device Manager, then select it in your HART application.

For supported operating systems, release notes, and troubleshooting, refer to MACTek’s documentation.

MACTek VIATOR Interface Installation is developed by MACTek. The most popular version of this product among our users is 1.0.